Settingthe Plug-Lnjumpers - Siemens SIMATIC S5 IP 281 Equipment Manual

R 11192
Setting the Plug-In Jumpers
Location of the The design of both counters is identical (i.e., the location of the components
plug–in jumpers on the module and the plug–in submodule are geometrically identical).
This makes it easier to set the plug –in jumpers.
The settings are made with plug–in jumpers X20, X30 to X39 (basic
module) and X40 to X49 (plug–in submodule).
Plug–in jumper X20 affects both counters.
Counter 1 is set with X30to X39; counter 2 is set with X40 to X49. Plug–in
jumpers with the same relative position have the same function.
Plug–in jumper X20 can be used to switch the EMERGENCY OFF function
digital outputs
Status on Delivery
@SiemensA(31992, Order
purposes. Leave them open.
Jumper X20
Not permitted
The digital outputs are switched off when the BASP
signal is active.
The digital outputs are not switched off when the
0 0 — — — 0
1 2 3
Warning
When the plug–in jumper is inserted on 2–3, the digital
output is not switched off even when an error occurs. This
can lead to destruction of system components and injury to
persons.
Jumper X20
The digital outputs are switched off when the BASP
1 2 3
signal ia active.
Hardware Settinas
Effect
Effect
2 – 7