Table of Contents
Advertisement
Figure 73 Force Charge Setting Interface
Step 12: If you want to use force charge,
sett Enable here.
Figure 75 UPS Reserve SOC Setting Interface
Step 14: Set the UPS Reserve SOC, it
means how much battery energy to keep
for UPS function.
Figure 77 Date&Time Setting Interface
Step 16: Click System in the setting
menu. Click Date &Time and set up the
date and time.
NOTE: It is needed to set the following 3 parameters for manual mode:
IP Address: IP address;
Subnet Mask: Subnet mask;
Default Gateway: Default gateway;
___________________________________________________________________
Figure 74 Force Charge Time Setting Interface
Step 13: Set the charge and discharge
time.
Step 15: Click Safety in the setting
menu. Set safety standard.
AS4777 for Australia, ARN4105 for
Germany, CEI0_21 for Italy, G83_2 for
Great Britain
Step17: Click Ethernet to set the IP
address. DHCP mode means that setup
IP address is set up automatically.
If you want to set up the IP address
manually, please choose manual mode.
United Renewable Energy Co., Ltd.
Figure 76 Safety Setting Interface
Figure 78 Ethernet interface
Page 40 of 45
Advertisement
Table of Contents
