6.
Enter the vertical size of the copy with the number keys, and then press [ ].
7.
Press [OK] twice.
• The horizontal and vertical length of an original can be entered in steps of 1 mm (0.1 inches). The
horizontal length of an original can be 1 to 9999 mm (0.1 to 99.9 inches); the vertical length of an
original can be 1 to 999 mm (0.1 to 99.9 inches). The horizontal and vertical length of copies can
also be entered in steps of 1 mm (0.1 inches). Both the horizontal and vertical length of copies can
be 1 to 999 mm (0.1 to 99.9 inches).
• To change the value you entered, press the key you want to change, and then enter a new value.
• The machine selects reproduction ratios of between 25 400%.
• When entering a size in mm (inch), if the calculated ratio is over the maximum or under the
minimum ratio, it is automatically adjusted to within available range. However, with some ratios,
parts of the image might not be copied or margins will appear on copies.
Create Margin
Reduces the image to 93% of its original size and places the reduced image at the center. By combining
it with the Reduce / Enlarge functions, you can further increase a margin.
1.
Press [Create Margin].
2.
Select the reproduction ratio, if necessary.
• You can change the ratio for Create Margin under Reproduction Ratio in User Tools. For details
about Reproduction Ratio, see p.255 "Reproduction Ratio".
Advanced Reduce / Enlarge Copying
4
157