Enabling/Disabling The Pppoe Server To Output Ppp-Related Log; Displaying And Debugging Pppoe Server - H3C SecPath Series Operation Manual

Operation Manual – User Access
H3C SecPath Series Security Products
Perform the following configuration in system view.
Table 2-3 Configure PPPoE server parameters
Configure the maximum number of
PPPoE sessions allowed to be set up
with a remote MAC address
Restore the default maximum number of
PPPoE sessions allowed to be set up
with a remote MAC address
Configure the maximum number of
PPPoE sessions that a local MAC
address is allowed to set up
Restore the default maximum number of
PPPoE sessions that a local MAC
address is allowed to set up
Configure the maximum number of
PPPoE sessions that the current system
is allowed to set up
Restore the default maximum number of
PPPoE sessions that the current system
is allowed to set up

2.2.4 Enabling/Disabling the PPPoE Server to Output PPP-Related Log

To avoid decreased device performance due to excessive log output, you can disable
the PPPoE server to output log information.
Perform the following configuration in system view.
Table 2-4 Disable/enable the PPPoE server to output PPP-related log information
Disable the PPPoE server to output
PPP-related log information
Enable the PPPoE server to output
PPP-related log information
By default, the PPPoE server output the PPP-related information.

2.3 Displaying and Debugging PPPoE Server

After finishing the above configuration, execute the display commands in all views to
view the running state of the PPPoE configuration and to verify the effect of the
configuration.
Operation
Operation
2-3
Chapter 2 PPPoE Server Configuration
Command
pppoe-server max-sessions
remote-mac number
undo pppoe-server max-sessions
remote-mac
pppoe-server max-sessions
local-mac number
undo pppoe-server max-sessions
local-mac
pppoe-server max-sessions total
number
undo pppoe-server max-sessions
total
Command
pppoe-server log-information off
undo pppoe-server log-information
off