H3C SecPath Series Operation Manual page 17

Operation Manual – User Access
H3C SecPath Series Security Products
You must configure IP header compression at the endpoints of a link.
Perform the following configuration in interface view.
Table 1-16 Enable/disable IPHC
Operation
Enable IPHC.
Disable IPHC.
II. Configuring maximum number of compression-enabled TCP connections
You can configure maximum number of compression-enabled TCP connections.
Perform the following configuration in interface view.
Table 1-17 Configure maximum number of compression-enabled TCP connections
Configure maximum number of compres
sion-enabled TCP connections
Restore the default
The parameter number indicates the maximum connection number (from 3 to 256) of
TCP compression mode on the interface. It is 16 by default.
III. Configuring maximum number of compression-enabled RTP connections
You can configure maximum number of compression-enabled RTP connections.
Perform the following configuration in interface view.
Table 1-18 Configure maximum number of compression-enabled RTP connections
Configure maximum number of compres
sion-enabled RTP connections
Restore the default
The number argument specifies the maximum number of compression-enabled RTP
connections (in the range 3 to 1000) on the interface. It defaults to 16.
ppp compression iphc [ nonstandard ]
undo ppp compression iphc
Operation
Operation
1-15
Chapter 1 PPP Configuration
Command
Command
ppp compression iphc
tcp-connections number
undo ppp compression iphc
tcp-connections
Command
ppp compression iphc
rtp-connections number
undo ppp compression iphc
rtp-connections