Product Overview
The SPM Flex gas detector is available in two configurations, portable and fixed�
The portable model is equipped with a handle assembly and a shoulder strap�
The fixed model is supplied with a mounting bracket� If replacing an old SPM
detector, a retrofit bracket is available (see
bracket" on page
30)� All detectors are supplied with a power adaptor/charger
and cable, a CD containing the user manual, and a printed quick start guide�
WARNING
!
Operate and service the SPM Flex gas detector only as specified in this manual
and the accompanying quick start guide� Failure to do so may impair the
protection provided by the detector and may also void the warranty�
Initial setup
Prior to use, the detector requires some minimal setup:
•
Unpack the detector (save the packaging to re-use for service requests)
•
Read the quick start guide and this manual
•
For most gases, install a filter at the detector or at the end of a sample line
(see
"Detectable Gases" on page
Portable detectors
•
Connect the power adaptor/charger (in a dry, indoor location)
•
Charge for at least 4 hours (the detector can be used while being charged)
•
Open the detector's cover
•
Remove the rocker switch cover
•
Turn the rocker switch to the on position
•
Replace the rocker switch cover
•
Remove the paper optics card from the gate (save the card for later use)
•
Install a chemcassette
•
Configure the detector and begin to monitor (see
for basic display usage)
•
See
"Operation" on page 36
1 CUI Inc., part number SD190-24-U-ST, listed under UL file #E210311
SPM Flex Gas Detector
"Backward-compatible mounting
62)
"Operation" on page 36
and
"Accessories and Parts" on page 65
1
9