SPM Flex Gas Detector
Fixed detectors
•
Install the wall-mount bracket and mount the detector to it (see
mounting bracket" on page
•
Wire in accordance with local electrical codes utilizing a trained electrician
(see "Wiring and tubing" on page
•
Input
•
Honeywell-supplied power adaptor/charger (indoor, dry location use
only) or
•
24 VDC power supply
•
Signal (as desired)
•
4-20 mA
•
Relays
•
Ethernet
•
Open the detector's cover
•
Remove the rocker switch cover
•
Turn the rocker switch to the on position
•
Replace the rocker switch cover
•
Remove the paper optics card from the gate (save the card for later use)
• Install a Chemcassette cartridge
• Configure the detector and begin to monitor (see
basic display usage)
• See
"Operation" on page 36
Additional accessories
• External dust filters (required on inlet for most gases; see
on page 62�
• Tubing
• Sampling wand
• Mating signal connectors for fixed installations
The connectors and ports of a typical installation are shown in the figure below�
Sample in port
Ethernet
connector
Figure 1. Connectors and ports
10
29)
20)
"Navigation" on page 14
and
"Accessories and Parts" on page 65
Exhaust out port
Power connector
Relays or 4-20 mA connector
"Standard
for
"Detectable Gases"