Product Registration - Honeywell AreaRAE Plus User Manual

Product Registration

Register your product online by visiting:
https://sps.honeywell.com
By registering your product, you can:
Receive notification of product upgrades or enhancements
l
Be alerted to Training classes in your area
l
Take advantage of RAE Systems by Honeywell special offers and promotions
l
IMPORTANT! BUMP TEST THE MONITOR BEFORE EACH DAY'S USE
Prior to each day's use, every gas detection monitor should be bump tested to confirm the
response of all sensors and activation of all alarms by exposing the monitor to a concentration
of target gas that exceeds the low alarm set point. A bump test is also recommended if the
monitor has been subjected to physical impact, liquid immersion, an Over Limit alarm event, or
custody changes, or anytime the monitor's performance is in doubt.
To ensure greatest accuracy and safety, only bump test and calibrate in a fresh air environment.
The monitor should be calibrated every time it does not pass a bump test, but no less frequently
than every six months, depending on use and exposure to gas and contamination, and its
operational mode.
Calibration intervals and bump test procedures may vary due to local regulations.
l
Honeywell recommends using calibration gas cylinders containing the gas that is
l
appropriate to the sensor you are using, and in the correct concentration.
AreaRAE 5 User Manual