Setting Of Open And Close Positions; Adjustments; Function Modes; Photo Beams - DTS Alt 600 Installation Manual

Setting Open and Close
Positions
5.1) Press and hold SET(K1) until the LED displays the
letter 1.It turns into opening position learn state.
5.2) Now press UP(K3) again and hold, the door will travel
to the open position, release the button when the
door has reached the desired position.
5.3) If the door has overrun its position, press DOWN(K4) to
move the door downwards. Adjust and fine tune the
position by pressing UP(K3) and DOWN(K4).
5.4) Press SET(K1) to set the open position the LED will
display the letter 2 it is now time to set the closed
position.
5.5) Press and hold DOWN(K4), the door will travel to
the close position release DOWN(K4) when the
door has reached the closed position.
5.6) If the door has overrun its position, press the UP(K3)
to move the door upwards. Adjust and fine tune the
position by pressing DOWN(K4) and UP(K3).
5.7) Press SET(K1) to confirm.
The door will now open and close automatically to map
the open and close sensitivity force requirements.
WARNING: Keep all persons and property clear of door
during the installation process.
5.8) The door is now set for normal operational mode.
IMPORTANT: Safety systems must be checked
regularly to ensure that maximum safety is
maintained at all times.

Adjustments

Normally, the force settings are automatically set and
adjustment is not necessary. However, the force can be
adjusted by an authorized smart opener's installer for
special purposes if necessary.
6.1) Press SET(K1) and hold until the LED display
setting number 3, release SET(K1) the force setting no.
will appear 1-9, it is now in force adjustment mode.
6.2) Press UP(K3) to increase the force one-degree and
press DOWN(K4) to decrease one degree. Maximum
degree is 9 and the minimum is 1.
6.3) Press SET(K1) to confirm.
6.4) The door meets and hinders and rebounds 15 --20cm.

Function Modes

The unit has two selectable functioning modes, PHOTO
BEAM , AUTO CLOSE DOOR and LOCK DOOR.
7.1) PHOTO BEAM:
Make sure the photo beam has been installed correctly
before setting the PHOTO BEAM function.
7.1.1) Press DOWN(K4) & hold until the LED displays –
7.1.2) Press DOWN(K4) once, the LED displays || the photo
beam is now disabled. Press DOWN(K4) again the
LED displays H, the photo beam is enabled.
7.1.3) Press SET(K1) to confirm and quit.

7.2) TO SET AUTO-CLOSE ON / OFF :

7.2.1) Press UP(K3) and hold until the LED displays –
7.2.2) Press UP(K3) once, the auto close time
increase 1 minute; Press DOWN(K4) once,
decrease the auto close time 1 minute,
the LED display the current set value.
7.2.3) The Auto Close function will be disable
when the setting time is 0.
7.2.4) Press SET(K1) to confirm and quit when the
correct time is set.
7.2.5) Infra Red Beams must be fitted if autoclose is on.
7.3) HOLIDAY LOCK-OUT:
7.3.1) Press SET(K1) and hold until the LED display
setting number 4, release SET(K1), it is
now in holiday lock-out program.
7.3.2) Press UP(K3), LED display 1 holiday lock-out
is now activated or press DOWN(K4), LED display 0
holiday lock-out is now de-activated.
-9-