Diagram To Connect Ir Beams To Pcb; Load Setting; Pcb Control Card. - DTS ECO 500 Installation Manual

Diagram to connect IR Beams to PCB

Note: If sentry beams are fitted, then SBEAM, N/C on the PCB must be connected to N/O on the RX.
Pedestrian Opening (Default 1 meter / 8 seconds auto close)

Load setting

To adjust the load turn the load pot to determine the load setting (Minimum, anticlockwise & Maximum, clockwise).

PCB Control card.

(Please note, can only connect a low voltage power supply and therefore cannot be modified as a High excess motor)
4