Self-Learning Transmitter; Maintenance; Technical Specifications; Final Notes - DTS Alt 600 Installation Manual

Self Learning Transmitter
8.1) Press CODE(K2), release when the LED displays ..
Press a button on the transmitter then release and
press again the dot will flash to confirm the code
8.2) Repeat step 1 to code a maximum of 20 different
transmitters' and./or buttons.
8.3) To delete all stored codes, Press and hold CODE(K2)
the LED display dot flash .,keep holding for approx 8
seconds until the LED display C all the settings
is now deleted.

Maintenance

No particular maintenance is required for the logic circuit
board.
Check at least twice a year the door is properly balanced
and that all working parts are in good working condition.
IMPORTANT: A poorly operating door can effect the life of
the automatic opener due to incorrect loads and will void
the warranty.
Check the reversing sensitivity at least twice a year and
adjust if necessary.
Make sure that the safety devices are working effectively
(photo beams, etc.)

Final Notes

This manual is only for use by technical personnel
qualified to carry out the installation.
No information given in this manual can be considered of
any interest to the end user.
No setting or adjustments contained in this manual can
be carried out by the end user.
It is important for the installer to show their clients correct
operational use of the Alt 600 including the use
manual disengagement cord.
Inform the owner about the need for a regular and
accurate maintenance, especially regarding a regular
check of the safety and reversing devices.

Technical Specifications

Power Input:
Motor:
Courtesy light time:
Working temperature:
Relative Humidity:
Open and close force:
Reception frequency:
Sensitivity:
Decoding:
Transmitter power:
Globe:
NOTE: DTS Security reserves the
right to modify its product and product specifications
at any time without prior notice.
Typical Application
The Alt 600 (max.2500mm travel) model can
automate sectional overhead doors up to a height of
2600mm and tilting overhead doors up to 2600mm.
-10-
220 VAC 50Hz
24V DC 100W
3 minutes
-20° ~ 70° C
<90%
600 N
433.92MHz
>1 V for correct receiver signal
(average range 50m, with an
aerial)
Rolling code
12V Battery
220V 25 watt screw type