Table of Contents
Advertisement
Contents
No
Package
1
Motor
2
Rail
Important Safety Warnings
The Alt 600 garage door opener described in this
manual is designed for the automation of residential
sectional overhead doors and one piece overhead tilting
doors. Any other use is considered improper and will void
the warranty.
WARNING:
You are carrying out operations on machine systems
classified in the automatic gates and doors category and
as such failure to comply with the relevant safety rules
may result in serious personal injury and/or property
damage.
Only qualified personnel should install and service the
equipment. It is the responsibility of the installer to adhere
to all relevant safety standards.
Description
The Alt 600 garage door opener requires a 220VAC
50Hz power input and has a 24V DC 100W motor and
can provide 'Hold to Run' control and automatic modes for
operation. When the door is in operation, movement can
be interrupted by activation of the safety inputs (manual
pull cord, transmitter, wall button (if fitted) and photo
beams (if fitted).
An encoder sets open and close positions and braking
during the end of the travel cycle reducing speed and
noise.
Part
No Description
1
Motor
2
Transmitter
3
Remote Wall Switch
4
Remote Wall Switch Bracket
5
Disengagement Cord
6
Clutch
7
Bracket
8
Bracket
9
Strapping
10 Connector
11 Bolts/Nuts
12 Installation Manual
1
Extrusion
Unqualified personnel or those who do not know the
occupational health and safety standards applicable to
automatic gates and doors category must under no
circumstances carry out installations or implement
systems.
Persons who install or service the equipment without
observing all the applicable safety standards will be held
responsible for any damage, injury, cost, expense or
claim whatsoever suffered by any person as a result
whether directly or indirectly from failure to install the
system correctly and in accordance with the relevant
safety standards and installation manual.
A 433.92MHz radio receiver is built into the circuit board
and the rolling code is memorised with the self-learning
technique. As an alternative to the built-in receiver the
unit will accept any of the range of stand alone radio
receivers. The unit has been designed to provide
maximum reliability, safety and flexibility of use.
IMPORTANT: Before starting to install the unit read
all of the instructions carefully and make sure you
are familiar with the safety warnings included in this
manual.
-3-
Qty
Remark
1 Set
2 Pcs Transmitter
1 Pc
Not Supplied
1 Pc
Not Supplied
1 Pc
1 Pc
1 Pc For Track
1 Pc For Door Panel
4 Pcs For Rail
2 Pcs For Door Panel
1 Set
1 Pc
1 Set
Hide quick links:
Advertisement
Table of Contents
