DTS Alt 600 Installation Manual page 7

Installation
there are specific standards that have to
Remember
be strictly followed regarding the safety of electrical
installations and automatic gates and doors.
As well as the legal requirements and standards that
must be adhered to, please take note of the following
points to ensure maximum safety and reliability of your
installation.
3.1) Prior to installing check the surrounding environment.
Carefully evaluate any hazards there could be from
physical damage (transiting vehicles, parts of trees
falling etc.), possible contact with foreign bodies
(insects, leaves, etc.), Flooding hazards or any
others exceptional events.
3.2) Check that the main voltage is the same as that given
on the rating plate and in this manual.
3.3) Check there is suitable electrical protection against
short circuits/power spikes and proper earthing on
the main supply.
the unit has mains voltage running through it
Remember
(electrocution hazard, fire hazard).
3.4) Take care with the control unit; parts may be
subject to damage if abused.
3.5) Make sure you have all the necessary materials
and that they are suitable for this kind of use.
3.6) Read all the instructions thoroughly and make sure
they are understood before attempting to install the
Alt 600.
3.7) Before starting the installation, carefully analyse all
the risks relating to automating the door. Verify that
the door to be automated is in a sound condition
and that the mechanisms are in good working order;
observe the safety margins and minimum distances.
3.8) Evaluate with particular care the safety devices to be
installed and where to install them; always install an
emergency stop device for interruption of power to
the opener if required.
3.9) Once the risks have been analysed, install
the Alt 600 opener and relative safety
devices, emergency stop and/or photoelectric
cells.
Important: Infra Red Beams must be fitted if autoclose
is activated.
3.10) When installing the Alt 600 opener, strictly follow
all the instructions given in the instruction manual. If
some points or procedures in this manual are not
very clear do not install the unit until all doubts have
been cleared up with our technical department.
-7-