Table of Contents
Advertisement
SECTION 6,
continued
6.2 Sending Data to Printers/Computers
6.2.1 Sending Currently Displayed Data
6.2.2 Sending Recalled Data Points
6.2.3 Sending All Stored Data
To print or transfer a current reading:
1. Wait until the display is stable. Press
2. The word
PRINT
will return to Reading mode.
3. The printout for data that is not stored will not have a storage
location number.
1. Recall data by following the steps in Section 4.2 on page 46.
2. When the desired sample data is displayed, press
3. The word
PRINT
4. Press
to print the recalled data point.
ENTER
5. Press
to return to the reading mode.
EXIT
1. To transfer all data, a data point must be recalled first. See
Section 4.2 on page 46.
2. When a data point is displayed, press
3. Press the
UP ARROW
with the
(flashing). At this point the options are:
?
a. Press
to return to the next data point in Recall mode
EXIT
without printing.
b. Press the
DOWN ARROW
printing single data points.
55
PRINT.
will be briefly displayed, then the meter
and a flashing
will be displayed.
?
PRINT
. The instrument will show
to return to the prompt for
.
PRINT
.
and
Print
All
Advertisement
Table of Contents
