Thermoplan BLACK&WHITE 3 Series User Manual page 5

Installation and putting into operation
Important hints
DISPOSAL Packaging Material:
Disassembly of Equipment:
Safety Instructions:
Disposal Instructions:
GENERAL SAFETY 1.
HINTS
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
© 2009 by Thermoplan AG , Subject to change
User Manual CT / CTS / CTMcool
The packaging material (cardboard, plastic foil PE and polystyrene EPS) must be recycled.
Disconnect equipment from power. If the equipment is hard-wired it must be disconnected by an
authorized service agent!
In order to avoid any accidents caused by inappropriate use or in particular by playing children
the equipment must be put out of operation. Unplug unit from power source or in case of have
hardwired installations have it disconnect by an authorized service agent! Subsequently cut off plug
from power cord.
The proper disposal of your old appliance will help prevent damages to the environment and
injuries to human health. The old equipment is not worthless waste. If disposed properly it is possible
to recycle its raw materials. Make sure that the old equipment is disposed of or recycled according
to local regulations. For any further information about disposal, please contact your manufacturer
agent.
In case of an emergency, immediately remove the plug from the power socket.
Check that the voltage quoted on the rating plate is the same as your mains voltage.
Use only the specific power supply cord. The use of incorrect connections voids the warranty!
Your machine is made for indoor use only.
The hot water tube, steam, hot water and coffee are very hot. Avoid direct contact with the skin.
(Danger of burning/scalding)!
Remove the plug from the mains socket if you will not be using the machine for an extended time (holidays).
Before cleaning and servicing, remove the plug from the mains socket and let the machine cool down. Do not unplug by
pulling the cable.
Do not use the machine if it is not operating perfectly or if is shows any sign of damage. In case of any malfunction or
damage notify your nearest service agent.
Never immerse the machine, cable, or plug in water or any other liquid.
Keep the power cord out of reach of children.
Never leave the power cord near or in contact with hot parts of the machine, a source of heat, or a sharp edge.
When the power cord or plug is damaged, you may not use the machine. In order to avoid danger, have the defective part
repaired or replaced by.
Never place the machine on a hot surface, e.g. a heating plate. Never use it around an open flame.
Place the machine on a flat, stable, heat resistand surface...
805.012_REV-1_EN
5