Thermoplan BLACK&WHITE 3 Series User Manual page 24

User display messages
Display messages
Milk low
Foamer off
Powder error
Change filter
Service required
Clean appliance
Flow error
Voltage high
109%
Voltage low
91%
© 2009 by Thermoplan AG, Subject to change
User Manual CT / CTS / CTMcool
What?
• Milk level is low
- Fill milk container
• Defective milk level
=> Contact service
• Milk circuit is turned OFF
- If needed turn Foamer ON
- Simultaneously press and hold the "Double Product" key and any "Milk" beverage key.
The display shows Foamer On
• Too much coffee is being ground and exceeds the fill capacity of the brew chamber
1. Clear error with the „Step" key
2. Reselect the same beverage again
3. If error message reappears check powder quantity and if needed readjust grinder
to a finer grind
• The water filter system needs maintenance. The message remains on the display
until the water counter is reset to 0. All beverages can be produced.
=> Contact service
• He machine has reached the number of programmed coffee cycles and
a preventative service must be performed
=> Contact service
• The machine has reached the programmed number of coffee cycles and
a cleaning cycle must be performed.
- Cleaning cycle must be performed
• No water supply
1. Check
2. => Contact service
• No water pressure to machine
- Check water pressure to coffee boiler, (min 2 bar)
• Function Voltage Control active (Voltage is too high)
- As soon as the voltage drops down to the programmed value all products can be
produced again.
• Function Voltage Control active (Voltage is too low)
- As soon as the voltage goes up to the programmed value all products can be
produced again
805.012_REV-1_EN
24