Other Messages - Sony UP-DF750 Setup And User's Manual

2) If the error has occurred on one tray only, the ALARM indicator
will not light, and the READY indication is always shown. In
this case, instead of an error message, the tray status indication
on the LCD panel changes as follows.
Corresponding error
message
2)
[*] Check Tray
[*] Set Film
2)
[*] Tag Mismatch
2)
[*] Tag Invalid T
[*] Tag Invalid I
Remove Prints

Other messages

Besides messages indicating an error, various status
messages may also be shown on the LCD panel, as listed
below.
In these cases, the ALARM indicator does not light.
Status
Job information
Message
Please Wait
----------------------------------
Head Cooling
Please Wait
----------------------------------
Head Heating
Please Wait
----------------------------------
–
46
Messages
Tray status indication
Chk Tray
Set Film
Tag Err M
Tag Err T
Tag Err I
Rmv Prt
Cause/Countermeasures
The thermal head temperature has
exceeded normal levels.
tWait until the message disappears.
During continuous printing, operation
will resume when the head has cooled
down and the message disappears.
The thermal head is currently being
warmed up.
tWait until the message disappears.
Printing will start when the head
has been warmed up and the
message disappears.
The printer is performing an internal
processing operation such as when
the film tray is opened or closed. The
message is also shown during power-
down.
tWait until the indication
disappears.
Message Cause/Countermeasures
Indicates that the printer is carrying
out an initialization routine, such as
Initializing (Flashes)
when the cover was closed or a
----------------------------------
network setting such as the IP address
was changed.
–
tWait until the indication
Processing Image data are being processed.
Reserved
----------------------------------
–
In the current condition, a problem
could occur due to the combination of
–
the size of film inserted in the film
---------------------------------- tray and the type of output tray that is
installed. (page 15)
Output Tray
Contact your Sony dealer to have the
Mismatch
output tray size changed.
(The part above the dotted line refers to the status indication, and the
part below the dotted line refers to the job information field.)
disappears.