Connections; Turning The Unit On Or Off - Sony UP-DF750 Setup And User's Manual

Connections

Connect the unit to a LAN.
Notes
• Turn off the power of each device before attempting to
make any connections.
• Connect the AC power cord last.
• Before connecting to the LAN, be sure to set up the
required IP address and sub-net mask.
For detailed information, consult the system
administrator.
to the network connector
LAN cable
to the LAN
Notes on the LAN cable
• Be sure to use a LAN cable of less than 30 m (98 feet
5 1/4 inches) in length, and rated more than category 5e.
• It is recommended that you use a shielded cable.

Turning the Unit On or Off

Turn the printer power on after you connect the AC power
cord.
Turning the main power of the unit on
Set the ?/amain POWER switch to the on (=) side.
The unit is not turned on even if the ?/amain POWER
switch of the unit is turned on.
Turning the unit on
Use the 1ON/STANDBY switch located on the front of
the unit to turn the unit on during daily use.
1
to- AC IN
Power cord
?/a
main
POWER switch
Note
1
Press the 1ON/STANDBY switch to set the unit to
on.
The 1ON/STANDBY indicator lights up in green,
and the "Film Station" logo is shown on the LCD
panel. Then the following screen appears.
After a few minutes, the following message should
appear.
17
Connections