Messages; Error Messages - Sony UP-DF750 Setup And User's Manual

Messages

There are two kinds of messages: error messages and
warning messages. This section lists these messages
together with their possible causes and remedies. Note the
messages and act accordingly.
Besides error and warning messages, other messages
stating the operating status of the unit are also displayed.
Those messages are not described here.

Error Messages

If a problem occurs, the ALARM indicator lights and an
error message as well as an illustration indicating required
steps appear on the LCD panel. Perform the appropriate
action, as indicated below.
Message Cause/Countermeasures
Close Cover The front, rear, or top cover is open.
tClose the cover.
Memcon/0 Trouble An internal error has occurred in the
Memcon/1 Trouble printer.
tPress the 1 ON/STANDBY
Mecha Trouble A mechanical problem has occurred
(Mechanical problem) in the printer.
tPress the 1 ON/STANDBY
switch to turn power off, and then
turn power on again by pressing
the 1 ON/STANDBY switch
once more. Normally this will
restore correct operation. If the
above steps do not provide a
solution and the message appears
again, turn power to the unit off
and contact your Sony dealer.
switch to turn power off, and then
turn power on again by pressing
the 1 ON/STANDBY switch
once more. Normally this will
restore correct operation. If the
above steps do not provide a
solution and the message appears
again, turn power to the unit off
and contact your Sony dealer.
Message Cause/Countermeasures
1)
Remove FilmXXXXXX Film has jammed at the location
indicated by XXXXXX. Refer to the
illustration shown on the LCD panel
and remove the jammed film.
Error Internal system of printer could not
Please Power OFF be started.
Power ON Again tPress the 1 ON/STANDBY
[*] Set Tray The required film tray is not installed.
tInstall the required film tray.
2)
[*] Check Tray Film is not loaded correctly in film
tray.
tLoad film correctly. (page 19)
Set Output Tray Output tray is not installed correctly.
tMake sure that output tray is
2)
[*] Set Film Film sheets in the specified tray have
run out.
tLoad film sheets.(page 20)
2)
[*] Tag Mismatch The IC tag setting of the film sheets
in the tray does not match the IC tag
setting at the printer.
tInsert film sheets from a package
tIf this does not clear the error,
2)
[*] Tag Invalid T There is a problem with the IC tag.
tInsert film from a new package.
2)
[*] Tag Invalid I
tIf this does not clear the error,
Remove Prints Printouts have accumulated on the
output tray.
tUnload the accumulated printouts.
Dicom Trouble There is a problem with the DICOM
section.
tPress the 1 ON/STANDBY
[*] stands for the tray number (1 or 2).
1) "XXXXXX" indicates the location where the film jam has
occurred. For details, see "If the Film Sheets Jams" on page 47.
switch to turn power off, and then
turn power on again by pressing
the 1 ON/STANDBY switch
once more.
(page 19)
pushed all the way in. (page 15)
designed for use with this unit.
(page 19)
press the 1 ON/STANDBY
switch to turn the unit off, and
contact your Sony dealer.
press the 1 ON/STANDBY
switch to turn the unit off, and
contact your Sony dealer.
Printing starts again. (page 25)
switch to turn power off, and then
turn power on again by pressing
the 1 ON/STANDBY switch
once more. Normally this will
restore correct operation. If the
above steps do not provide a
solution and the message appears
again, turn power to the unit off
and contact your Sony dealer.
Messages
45