Tilting The Bench Drill Assembly; Turning The Bench Drill Assembly; Horizontally Moving The Bench Drill Assembly - Westfalia ZQJ3116 Instruction Manual

Tilting the Bench Drill Assembly

The bench drill assembly can be tilted up to 45° in clockwise direction and up to
90° counter clockwise.
1. To adjust the inclination angle, first loosen the right clamp bolt (E
2. Pull out the lock pin (87) that is situated on the left side of the headstock and
turn the pin up to 90°.
Part 88
Line
1. Finally tilt the bench drill assembly to the desired angle. With the marking line
on the column you can read the inclination angle on the degree scale (90).
Tighten the clamp bolt again.
2. To turn back the bench drill assembly to the basic position, first loosen the
clamp bolt (E

Turning the Bench Drill Assembly

1. Unscrew the left clamp bolt (E
headstock into the desired position.
2. Tighten the clamp bolt.

Horizontally Moving the Bench Drill Assembly

1. To move the bench drill assembly horizontally on the horizontal column, fist
loosen the right clamp bolt (E
Adjustments
Guide
), and tilt the drill assembly back. Re-tighten the clamp bolt.
1
Part 85
E
1
) on the bench drill assembly and turn the
2
).
1
30
).
1
Guide