Adjusting The Drill Table; Depth Stop - Westfalia ZQJ3116 Instruction Manual

Adjusting the Drill Table

The drill table is fixed with a clamp
bolt (11) on the column.
1. Loosen the clamp bolt (11) in
order to adjust the height of the
drill table.
2. Turn the crank (K). After adjusting
the desired height, re-tighten the
clamp bolt.
3. Make sure there is still enough
space between the work piece
and the drill bit tip.

Depth Stop

The depth stop with the swivelling
scale can be used to exactly adjust the
drilling depth.
1. Clamp the drill bit into the
drill chuck and clamp the
work piece on the drill table
by using a machine vice or
another suitable clamping
device.
2. Lightly pull down the feed
(F) with the handle until the
tip of the drill bit lightly
touches the work piece.
Adjust the drilling depth by
loosening the lock screw
(38) and adjusting the depth
stop.
The indicator (44) shows the selected drilling depth.
Adjust the depth stop resp. the drill table appropriately to make sure not to
drill into the machine vice or into the drill table.
Adjustments
Part 38
Part 44
29
Part 33
Work Piece
Part 11
K