Switching On And Off; Adjusting The Tool Speed; Sawing - Westfalia AMFW18 Instructions Manual

Switching ON and OFF

1. Set the variable speed dial (8) to the minimum speed.
2. Hold the tool firmly with the thumb over the ON/OFF Switch (3).
3. Slide the ON/OFF Switch forward until it locks, to switch the tool on.
4. Slide the ON/OFF Switch backwards, to switch the tool off.
WARNING: Allow the tool to reach the required speed before making
contact with the workpiece.
WARNING: Motor vents allow heat generated from the motor to escape
the body of the tool and must not become blocked. Dust, wood
chippings and swarf can block the motor vents and cause the tool to
shut down. Swarf, created when cutting metal, can also cause
permanent damage if it enters the tool. Do not allow dust, wood
chippings and swarf to build up. Use a vacuum cleaner to keep the
work space clean, especially in confined areas, and when working with
harmful substances.
WARNING: Do not inhale dust. Wear adequate breathing protection.
Some dusts may be toxic especially from man-made composite
materials.

Adjusting the Tool Speed

 The oscillating speed of this multi-tool can be adjusted over the
variable Speed dial (8).
 Turn the variable speed Dial to a higher setting, to increase tool
speed.
 Turn the variable speed dial to a lower setting, to decrease tool
speed.
Note: Adjust tool speed to best suit the work carried out, and to adapt
to material requirements. Also refer to the accessory manufacturer's
instructions, with regards to tool speed selection.

Sawing

 Ensure the saw blade is sharp and in good condition.
 Do not use saw blades that are damaged or bent in any way.
 When sawing light building materials, follow the recommendations of
the material suppliers.
Operation
31