How To Modify The Parameters - Emerson Dixell IEV22D Manual

3.10 How to modify the parameters

Proceed as follows to access the programming area of the parameters displayed in Pr1:
•
press SET and simultaneously for 5 seconds
•
press
•
press SET
•
press
•
press SET to confirm the value and move on to the next parameter
•
repeat the above steps to modify the other parameters
•
press SET and
Proceed as follows to access the programming area of the parameters displayed in Pr2:
•
press SET and simultaneously for 5 seconds
•
press
•
press SET
•
press
•
press SET to confirm the value
•
parameter Et01 will be displayed once again (in this case the parameters of level Pr2 are
displayed)
•
press
•
press SET if the parameter must be modified
•
press
•
press SET to confirm the value
•
press SET and
1592026260 IEV22-24D GB r.1.0 21.02.2019
Parameter displayed also in Pr2
to view the parameter that is to be modified
to modify the value of the parameter
simultaneously to exit from the programming area of the parameters
to view the password Pr2 parameter (last parameter on the list)
to enter the value of the current password
to view the desired parameter
to enter the new value
simultaneously to exit from the programming area of the parameters
IEV 16/60