Table of Contents
Advertisement
Module design
● Enclosure for snap-on mounting to rails
● Ribbon cable connector (X1):
● Connector (X2), 2 x 12-pole:
● 1 terminal pair X3: 1P, 1M (voltage supply on SIMATIC TDC side)
● 1 terminal pair X4: 2P, 2M (voltage supply on plant side)
● Pin header for short-circuit plugs
● Double test socket X5:2P (+), 2M (G)
● LED displays for diagnostics
● Optocoupler for electrical isolation between inputs and outputs
Voltage supply on SIMATIC side
The SIMATIC TDC voltage supply is fed to terminal X3:
Connect the cables using accessory kit SM11 "Power supply connector for interface
modules" (MLFB: 6DD1680-0BB0)
The maximum conductor cross-section at terminal X3 is 2.5 mm².
Green LED
The voltage supply on SIMATIC side is displayed with a green LED (P).
Red LED
The supply voltage on SIMATIC TDC side (1P, 1M) is short-circuited (fault).
SIMATIC TDC hardware
System Manual, 12/2013, A5E01114865-07
– 8 pins for digital outputs
– 2 pins for 1P, 1M
– 8 terminals for 24 V digital inputs
– 8 terminals for 48 V digital inputs
– 8 terminals for reference potentials
Terminal X3
1P
1M
7.3 Interface module SB61
Voltage on SIMATIC TDC side
+24 V
0 V
Interface module
169
Advertisement
Table of Contents
