Table of Contents
Advertisement
5. Cabinet + Frame Installation
◇ Half-cabinet Z-step adjustment
- Each Half-Cabinate has eight height controls. (4 corners / 4 sides)
- Two Half-Cabinet Z-Step adjustments are as follows
① Check the corner of the Half-Cabette to check if there is a difference.
② If the necessary part is the outer part, turn the exposed sawtooth to adjust the step.
③ If the internal part of Half-Cabinet needs adjustment, move left and right to secure space for adjustment.
Up, left, and right 2mm can be moved between each half-cabinet.
④ Adjust the step by turning the sawtooth using the step control jig. It is possible to flow 1mm in one lap.
※ The product in the shipment state can no longer be lowered because the module is located on the lowest cross section and
can be adjusted by raising the height.
Fig.1 Step check point (2x2 case)
.
2.0mm
2.0mm
2.0mm
2.0mm
Fig.2 Securing the space between modules when controlling the step
2.0mm
3~4mm
2.0mm
Samsung Electronics
41
41
Hide quick links:
Advertisement
Table of Contents
