Krups ESPRESSO AUTOMATIC EA88 Series Manual page 27

Preparing other drinks:
THE "ONE TOUCH CAPPUCCINO" BLOCK
This "One Touch Cappuccino" block facilitates preparation of one or two cappuccinos or
cafe lattes.
CAPPUCCINO/LATTE
- Preparing your appliance:
Connect the milk suction pipe on the left to the "One Touch Cappuccino" block. Place the
other end in a container filled with milk Fig. 11. You can prepare one or two cups with your
appliance at the same time.
Position your cup or cups and set the button on the block to the desired position:
cappuccino or latte
Fig. 12.
- Settings and making drinks
Press the "Cappuccino Latte" button (1 cup) or the "Cappuccino x 2" button (2 cups).
All settings can be modified.
For each cappuccino, the machine will take into account the last recipe used.
Once the settings have been defined, press OK.
The steam is used to froth up the milk. As the production of steam requires a high
temperature, the appliance has an additional pre-heating phase.
The following stages are automatically sequenced: frothing of the milk, grinding of the coffee
and preparation of the coffee.
Your drink is ready for you to enjoy Fig. 13.
FROTHED MILK
- Prepare your Appliance
Attach the milk suction pipe on the left-hand side of the "One Touch Cappuccino" block.
Plunge the other end into a container filled with milk Fig. 11.
Position the cup or cups and select cappuccino using the appliance's button. The steam is
used to froth up the milk. As a higher temperature is required when producing steam than
when making an espresso, the appliance will launch an additional pre-heating phase.
Select the Frothed Milk recipe on the screen. You can customise the frothing duration using
the menu. You can change it using the + or - buttons, then press "OK" The latest frothing
duration selection will be memorised for the next recipe.
RINSING THE "ONE TOUCH CAPPUCCINO" BLOCK
We advise you to rinse the "One Touch Cappuccino" block after every time you make a
milk-based recipe.
Thus, at the end of the recipe, an alert appears on the screen to remind you.
To start rinsing, simply press the alert pictogram. If not, it will be carried out automatically
when the coffee maker is switched off at the time when you decide to switch it off.
You can also start the rinsing through the maintenance menu. To do this, press the "Prog"
button ==> Maintenance" ==> "Accessory rinsing".
HOT WATER
Select the Hot Water recipe on the screen. Place the cup(s) under the coffee nozzles.
You can change the height of the coffee nozzles to suit the size of your cup or cups. Fig. 10.
You can change the quantity using the + or - buttons. Press the "OK" button to start the
preparation.
You are still able to increase or decrease the amount of water for your drink during its
preparation.
29