Configuring Data Damping Period; Configuring A Channel In Rotational Rate Mode; Configuring Instance Number; Configuring Label - Maretron CLM100 User Manual

4.17.6 Configuring Data Damping Period

You can configure a damping parameter to smooth the decibel readings or make them more
responsive. The data damping is configurable between 0.2-25.0 seconds with a resolution of
0.1 seconds. The default data damping for a channel in decibel mode is 0.2 seconds.

4.18 Configuring a Channel in Rotational Rate Mode

The following sections describe the parameters that are available for configuration for a
channel which has been set to rotational rate mode.

4.18.1 Configuring Instance Number

Program this parameter to match the desired instance number of the rotational rate reading for
this channel. You can program this parameter to any value between 0 and 252.

4.18.2 Configuring Label

Program this parameter with a text string which identifies the particular parameter being
monitored by this channel. Maretron display products will display this label text when you are
selecting data to display.

4.18.3 Units, Range, and Resolution

Maretron display products and software support the following units for display of rotational rate,
with the range and resolution shown in the following table (NOTE: the resolution may be
further limited by the capabilities of the CLM100; please refer to section 1.7 for details).
Unit
RPM

4.18.4 Configuring Rotational Rate at 4mA

Program this parameter to match the reading of the rotational rate transducer when it is
sourcing a current of 4mA. You can determine this value by examining the specification of the
rotational rate transducer being used.

4.18.5 Configuring Rotational Rate at 20mA

Program this parameter to match the reading of the rotational rate transducer when it is
sourcing a current of 20mA. You can determine this value by examining the specification of the
rotational rate transducer being used

4.18.6 Configuring Data Damping Period

You can configure a damping parameter to smooth the rotational rate readings or make them
more responsive. The data damping is configurable between 0.2-25.0 seconds with a
resolution of 0.1 seconds. The default data damping for a channel in rotational rate mode is 0.2
seconds.
Revision 1.0
Minimum Value
-32767
Maximum Value
32764
Resolution
1
Page 27