Table of Contents
Advertisement
CLM100 User's Manual
4.3.1 Configuring Instance
Program this parameter to match the desired instance of the DC current reading for this
channel. You can program this parameter to any value between 0 and 252.
NOTE
If one channel is configured to DC Voltage mode, a second channel is
connected to DC Current mode, and the instance numbers for the two
channels are the same, then the corresponding DC voltage measurement
and DC current measurement will be transmitted together in a single
message.
4.3.2 Configuring Label
Program this parameter with a text string which identifies the particular parameter being
monitored by this channel. Maretron display products will display this label text when you are
selecting data to display.
4.3.3 Units, Range, and Resolution
Maretron display products and software support the following units for display of DC current,
with the range and resolution shown in the following table (NOTE: the resolution may be
further limited by the capabilities of the CLM100; please refer to section 1.7 for details).
Unit
Amperes
4.3.4 Configuring DC Current at 4mA
Program this parameter to match the reading of the DC current transducer when it is sourcing
a current of 4mA. You can determine this value by examining the specification of the DC
current transducer being used.
4.3.5 Configuring DC Current at 20mA
Program this parameter to match the reading of the DC current transducer when it is sourcing
a current of 20mA. You can determine this value by examining the specification of the DC
current transducer being used.
4.3.6 Configuring Data Damping Period
You can configure a damping parameter to smooth the DC current readings or make them
more responsive. The data damping is configurable between 0.2-25.0 seconds with a
resolution of 0.1 seconds. The default data damping for a channel in DC current mode is 0.2
seconds.
Page 12
Minimum Value
-83886.08
Maximum Value
83886.05
Resolution
0.01
Revision 1.0
Advertisement
Table of Contents
