Configuring Instance Number; Configuring Label; Units, Range, And Resolution; Configuring Temperature At 4Ma - Maretron CLM100 User Manual

CLM100 User's Manual
 Sea Temperature
 Outside Temperature
 Inside Temperature
 Engine Room Temperature
 Main Cabin Temperature
 Live Well Temperature
 Bait Well Temperature
 Refrigeration Temperature
 Heating System Temperature
 Dew Point Temperature
 Wind Chill Temperature, Apparent
 Wind Chill Temperature, Theoretical
 Heat Index Temperature
 Freezer Temperature
 Exhaust Gas Temperature
 16 User Defined temperature sources (User Defined 129 – User Defined 144)

4.11.2 Configuring Instance Number

Program this parameter to match the desired instance number of the temperature reading for
this channel. You can program this parameter to any value between 0 and 252.

4.11.3 Configuring Label

Program this parameter with a text string which identifies the particular parameter being
monitored by this channel. Maretron display products will display this label text when you are
selecting data to display.

4.11.4 Units, Range, and Resolution

Maretron display products and software support the following units for display of temperature,
with the range and resolution shown in the following table (NOTE: the resolution may be
further limited by the capabilities of the CLM100; please refer to section 1.7 for details).
Unit
Degrees Celsius
Degrees Fahrenheit

4.11.5 Configuring Temperature at 4mA

Program this parameter to match the reading of the temperature transducer when it is sourcing
a current of 4mA. You can determine this value by examining the specification of the
temperature transducer being used.

4.11.6 Configuring Temperature at 20mA

Program this parameter to match the reading of the temperature transducer when it is sourcing
a current of 20mA. You can determine this value by examining the specification of the
temperature transducer being used.
Page 20
Minimum Value
-273.15
-459.67
Maximum Value
16504.1
29739.3
Resolution
0.001
0.0018
Revision 1.0