Table of Contents
Advertisement
CLM100 User's Manual
4.4.6 Configuring Flow Rate at 20mA
Program this parameter to match the reading of the flow rate transducer when it is sourcing a
current of 20mA. You can determine this value by examining the specification of the flow rate
transducer being used.
4.4.7 Configuring Data Damping Period
You can configure a damping parameter to smooth the flow rate readings or make them more
responsive. The data damping is configurable between 0.2-25.0 seconds with a resolution of
0.1 seconds. The default data damping for a channel in flow rate mode is 0.2 seconds.
4.5 Configuring a Channel in Distance Mode
The following sections describe the parameters that are available for configuration for a
channel which has been set to distance mode.
4.5.1 Configuring Instance Number
Program this parameter to match the desired instance number of the distance reading for this
channel. You can program this parameter to any value between 0 and 252.
4.5.2 Configuring Label
Program this parameter with a text string which identifies the particular parameter being
monitored by this channel. Maretron display products will display this label text when you are
selecting data to display.
4.5.3 Units, Range, and Resolution
Maretron display products and software support the following units for display of distance, with
the range and resolution shown in the following table (NOTE: the resolution may be further
limited by the capabilities of the CLM100; please refer to section 1.7 for details).
Unit
Mm
Cm
M
In
Ft
4.5.4 Configuring Distance at 4mA
Program this parameter to match the reading of the distance transducer when it is sourcing a
current of 4mA. You can determine this value by examining the specification of the distance
transducer being used.
Page 14
Minimum Value
-20,000,000
-2,000,000
-20,000
-787,401.6
-65,616.8
Maximum Value
20,000,000
2,000,000
20,000
787,401.6
65,616.8
Resolution
0.01
0.001
0.00001
0.000394
0.000033
Revision 1.0
Advertisement
Table of Contents
