Configuring Label; Units, Range, And Resolution; Configuring Dc Voltage At 4Ma; Configuring Dc Voltage At 20Ma - Maretron CLM100 User Manual

NOTE
If one channel is configured to DC Voltage mode, a second channel is
connected to DC Current mode, and the instance numbers for the two
channels are the same, then the corresponding DC voltage measurement
and DC current measurement will be transmitted together in a single
message.

4.2.2 Configuring Label

Program this parameter with a text string which identifies the particular parameter being
monitored by this channel. Maretron display products will display this label text when you are
selecting data to display.

4.2.3 Units, Range, and Resolution

Maretron products support the following units for display of DC voltage, with the range and
resolution shown in the following table (NOTE: the resolution may be further limited by the
capabilities of the CLM100; please refer to section 1.7 for details).
Unit
Volts

4.2.4 Configuring DC Voltage at 4mA

Program this parameter to match the reading of the DC voltage transducer when it is sourcing
a current of 4mA. You can determine this value by examining the specification of the DC
voltage transducer being used.

4.2.5 Configuring DC Voltage at 20mA

Program this parameter to match the reading of the DC voltage transducer when it is sourcing
a current of 20mA. You can determine this value by examining the specification of the DC
voltage transducer being used.

4.2.6 Configuring Data Damping Period

You can configure a damping parameter to smooth the DC voltage readings or make them
more responsive. The data damping is configurable between 0.2-25.0 seconds with a
resolution of 0.1 seconds. The default data damping for a channel in DC voltage mode is 0.2
seconds.

4.3 Configuring a Channel in DC Current Mode

The following sections describe the parameters that are available for configuration for a
channel which has been set to DC Current mode.
Revision 1.0
Minimum Value
0
Maximum Value
6553.2
Resolution
0.1
Page 11