Table of Contents
Advertisement
4.11.7 Configuring Data Damping Period
You can configure a damping parameter to smooth the temperature readings or make them
more responsive. The data damping is configurable between 0.2-25.0 seconds with a
resolution of 0.1 seconds. The default data damping for a channel in temperature mode is 0.2
seconds.
4.12 Configuring a Channel in Humidity Mode
The following sections describe the parameters that are available for configuration for a
channel which has been set to Humidity mode.
4.12.1 Configuring Source
You can configure a "Source" descriptor to be transmitted with the Humidity reading which is
used to provide an indication of the source of the Humidity data for this channel. Choices are
as follows:
Inside Humidity
Outside Humidity
16 User Defined humidity sources (User Defined 129 – User Defined 144)
4.12.2 Configuring Instance Number
Program this parameter to match the desired instance number of the Humidity reading for this
channel. You can program this parameter to any value between 0 and 252.
4.12.3 Configuring Label
Program this parameter with a text string which identifies the particular parameter being
monitored by this channel. Maretron display products will display this label text when you are
selecting data to display.
4.12.4 Units, Range, and Resolution
Maretron display products and software support the following units for display of temperature,
with the range and resolution shown in the following table (NOTE: the resolution may be
further limited by the capabilities of the CLM100; please refer to section 1.7 for details).
Unit
% Relative Humidity
4.12.5 Configuring Humidity at 4mA
Program this parameter to match the reading of the Humidity transducer when it is sourcing a
current of 4mA. You can determine this value by examining the specification of the Humidity
transducer being used.
Revision 1.0
Minimum Value
0
Maximum Value
100
Resolution
0.004
Page 21
Advertisement
Table of Contents
