Installation; Unpacking The Box; Choosing A Mounting Location; Mounting The Clm100 - Maretron CLM100 User Manual

Parameter
Force (Load Cell)
Pressure
Decibels
Rotational Rate

3 Installation

3.1 Unpacking the Box

When unpacking the box containing the Maretron CLM100, you should find the following items:
 1 – CLM100 Current Loop Monitor
 1 – Parts Bag containing 4 Stainless Steel Mounting Screws
 1 – CLM100 User's Manual
 1 – Warranty Registration Card
If any of these items are missing or damaged, please contact Maretron.

3.2 Choosing a Mounting Location

Please consider the following when choosing a mounting location.
1. The CLM100 is waterproof, so it can be mounted in a damp or dry location.
2. The orientation is not important, so the CLM100 can be mounted on a horizontal deck,
vertical bulkhead, or upside down if desired.
3. The CLM100 is temperature-rated to 55°C (130°F), so it should be mounted away from
engines or engine rooms where the operating temperature exceeds the specified limit.

3.3 Mounting the CLM100

Attach the CLM100 securely to the vessel using the included stainless steel mounting screws or
other fasteners as shown in Figure 1Figure 1 below. Do not use threadlocking compounds
containing methacrylate ester, such as Loctite Red (271), as they will cause stress cracking of
the plastic enclosure.
Revision 1.0
MechanicalForce
EnvironmentBarometric Pressure
Pressure/Vacuum (Barometric, Compress Air, etc.) Pressure
MechanicaldB
MotionRotational Rate
Menu Location
Page 5