Safety Restraint Belt - Jungheinrich EFG 213 Operating Instructions Manual

3.3

Safety restraint belt

F
Fit the safety restraint belt each time before starting the industrial truck.
The belt protects you from serious injury!
Protect the belt from contamination (e.g. cover it when the truck is idle) and clean it
regularly. Frozen belt locks or pulleys must be thawed out and dried to prevent them
from freezing up again.
Z
The dry temperature of the warm air should not exceed +60°C!
F
Do not alter the belt setting!
This will increase the risk of malfunctioning.
– Always replace the safety restraint belt after an accident.
– Only original spare parts must be used for retrofits or repairs.
F
Damaged or non-operational belts must only be replaced by contractual dealers or
branches.
Starting the industrial truck on steep slopes
The automatic blocking system locks the belt in the retractor when the truck is
positioned on a steep slope. This prevents the belt from being pulled out of the
retractor.
M
Carefully drive the truck off the slope and then put on the belt.
Hazardous situations
F
If the truck is about to tip over, do not undo the restraint belt and try to jump out.
This will only increase the risk of injury!
Correct procedure:
– Lean your upper body over the steering wheel.
– Grip the steering wheel with both hands and brace feet.
– Tilt your body in the opposite direction of fall.
E 14