Safety Restraint Belt - Jungheinrich EFG 535 Operating Instructions Manual

4

Safety restraint belt

F
Put on the safety restraint belt each time before starting the industrial truck.
The belt protects against serious injury.
Protect the belt from contamination (e.g. cover it when the truck is idle) and clean it
regularly. Frozen belt locks or pulleys must be thawed out and dried to prevent them
from freezing up again.
Z
The dry temperature of the warm air should not exceed +60°C.
F
Do not alter the belt setting.
This will increase the risk of malfunctioning.
– Always replace the safety restraint belt after an accident.
– Only original spare parts must be used for retrofits or repairs.
F
Damaged or non-operational belts must only be replaced by approved dealers or
branches.
Procedure in unusual situations
F
If the truck is about to tip over, never
undo the restraint belt and try to jump
out.
Jumping increases the risk of injury.
Correct procedure:
– Lean your upper body over the
steering wheel.
– Grip the steering wheel with both
hands and brace feet.
– Lean your body against the opposite
direction of fall
E 19