In-Ceiling Mounting; In-Ceiling Mounting Without Gang Box - HIKVISION TurboHD DS-2CE56D7T-IT Z Series User Manual

8. Adjust the camera according to the figure below
to get an optimum angle.
1) View the camera image with the monitor.
2) Rotate the panning table to adjust the pan
direction.
3) Loosen the tilting lock screw.
4) Rotate the tilting table to adjust the tilt
direction.
5) Tighten the tilting lock screw.
6) Rotate the camera to adjust the lens to the
surveillance angle.
9. Tighten the screws to secure the bubble to the
back box/base plate.
Gently remove the protection film, which protects the
bubble during installation, from the bubble after the
installation is complete.
5.3

In-Ceiling Mounting

You must purchase an in-ceiling mount separately if
you use in-ceiling mounting.
5.3.1

In-Ceiling Mounting without Gang Box

1. Drill the screw holes and the cable hole in the
ceiling according to the supplied drill template.
2. Secure the in-ceiling mount with two screws as
shown below.
3. Route the cables through the in-ceiling mount
hole and connect the corresponding cables.
4. Affix the camera to the in-ceiling mount with the
supplied screws.
UM DS-2CE56(D/F)7T-xITxZ TurboHD Dome Camera (UD00351B) 022220NA
Figure 6, 3-Axis Adjustment
Figure 7, Install the Mount
7