Figure 8-2 Configuration For Hardware Diagnostic T/M Operation - Hitachi S10mini LQS070 Hardware Manual

(2) Configuration for hardware diagnostic T/M operation
Power supply module
D.Station module
S10mini Station unit

Figure 8-2 Configuration for Hardware Diagnostic T/M Operation

(3) Executing the hardware diagnostic T/M
●
Module mounting and cable wiring
Mount the modules as explained in section "Figure 8-2 Configuration for
hardware diagnostic T/M operation". The DeviceNet cables are not required to
be connected.
●
Switch setup
To T/M startup, set the rotary switches on the module as specified in the following
list:
Node address setting switch
Slot setting switch (SLOT)
FUNC1 setting switch
(FUNC1)
FUNC2 setting switch
(FUNC2)
●
T/M execution
The T/M starts running when you turn the power OFF and then back ON.
The DeviceNet communication cables not required.
(NA-U) Select a setting of 0.
(NA-L) Select a setting of 0.
Select a setting of F.
Select a setting of 0.
Select a setting of 0.
− 87 −
8 MAINTENANCE