Related Manuals for Modular Closets Vista Short Tower
Summary of Contents for Modular Closets Vista Short Tower
-
Page 1: Assembly And Installation
1-844-969-4247 support@modularclosets.com SHORT TOWER ASSEMBLY AND INSTALLATION INSTRUCTIONS... -
Page 2: Parts List
ASSEMBLY AND INSTALLATION INSTRUCTIONS SHORT TOWER PARTS LIST BOX 1 BOX 2 FINISHED EDGE FINISHED EDGE Rear Hanging Cleat (Qty 2) Set Shelf (Qty 2) Cam Post (Qty 12) Camlock (Qty 12) Screw, Square Drive, 2.5" (Qty 4) BOX 3 Left Side Panel (Qty 1) Right Side Panel (Qty 1) FINISHED EDGE... - Page 3 ASSEMBLY AND INSTALLATION INSTRUCTIONS CUBBY TOWER Lay parts out on a protective surface to prevent damage. Tip: Spread out the cardboard packaging to use as a protective surface. Inventory parts against the Parts List. Make sure all parts are present before proceeding. 2.1 Install one Cam Post (H) into each of the sic holes on Left Side Panel (A) and Right Side Panel (B).
- Page 4 ASSEMBLY AND INSTALLATION INSTRUCTIONS CUBBY TOWER 3.1 Assemble Set Shelves (D) and Rear Hanging Cleats (C) onto Right Side Panel (B) by sliding the Shelves and Cleats onto the Cam Posts (H) on Side Panel. BE SURE dowel pins in Shelves and Cleats engage drilled holes in Side Panel, and all parts are pressed flush against Side Panel.
- Page 5 ASSEMBLY AND INSTALLATION INSTRUCTIONS CUBBY TOWER ARROW TOWARD CAM POST OPENING Insert Camlocks (H) in holes in Set Shelves (D) and Rear Hanging Cleats (E), with arrow pointing toward Cam Post opening. Be sure Camlocks engage Cam Posts, and are fully seated in Shelves and Cleats.
-
Page 6: Installation
ASSEMBLY AND INSTALLATION INSTRUCTIONS CUBBY TOWER WITH LEG WITHOUT LEG EXTENSION KIT EXTENSION KIT PILOT PILOT HOLES HOLES 12" FROM STUDS STUDS FLOOR INSTALLATION Determine the mounting location for the unit. The unit can be wall mounted or floor mounted (by installing the Floor Support Panels as shown in step 6). - Page 7 ASSEMBLY AND INSTALLATION INSTRUCTIONS CUBBY TOWER 8.1 Secure Rear Hanging Cleat (C) to studs using 2.5" screws (L). For each Adjustable Shelf (E), insert four Shelf Pins (J) into pin holes inside the Tower at the desired height. Rest Adjustable Shelves (E) on Shelf Pins (J).