Related Manuals for Modular Closets DOUBLE HANGING UNIT
Summary of Contents for Modular Closets DOUBLE HANGING UNIT
- Page 1 1-844-969-4247 support@modularclosets.com DOUBLE HANGING UNIT ASSEMBLY AND INSTALLATION INSTRUCTIONS...
-
Page 2: Assembly And Installation Instructions
ASSEMBLY AND INSTALLATION INSTRUCTIONS DOUBLE HANGING UNIT PARTS LIST BOX 1 BOX 2 FINISHED EDGE FINISHED EDGE Set Shelf (Qty 2) Rear Cleat (Qty 2) Hanging Rod (Qty 2) Rod Bracket (Qty 4) Cam Post (Qty 12) Camlock (Qty 12) Screw, 5/8"... - Page 3 ASSEMBLY AND INSTALLATION INSTRUCTIONS DOUBLE HANGING UNIT 2.1 Install one Cam Post (G) into each of the eight holes on Left Side Panel (A) and Right Side Panel (B). Tighten until Cam Posts are seated against Side Panels. 3.1 Assemble Set Shelves (D) and Rear Hanging Cleats (C) onto Right Side Panel (B) by sliding the Shelves and Cleats onto the Cam Posts (G )on Right Side Panel.
- Page 4 ASSEMBLY AND INSTALLATION INSTRUCTIONS DOUBLE HANGING UNIT 3.1 Install Left Side Panel (A) onto assembled Set Shelves (D) and Rear Hanging Cleats (C). BE SURE dowel pins in Shelves and Cleats engage drilled holes in Left Side Panel, and Left Side Panel is pressed flush against Set Shelves and Cleats.
-
Page 5: Installation
ASSEMBLY AND INSTALLATION INSTRUCTIONS DOUBLE HANGING UNIT PILOT HOLES STANDARD HEIGHT 84" FROM FLOOR STUDS INSTALLATION Determine the mounting location for the unit. Using a stud finder, locate studs to which the unit will be secured. Mark stud locations with a pencil. - Page 6 ASSEMBLY AND INSTALLATION INSTRUCTIONS DOUBLE HANGING UNIT 7.1 Secure Rear Hanging Cleats (C) to studs using 2.5" Screws (J). Tighten Screws using Square Drill Bit (provided) and Drill.
- Page 7 ASSEMBLY AND INSTALLATION INSTRUCTIONS DOUBLE HANGING UNIT 8.1 Install two Rod Brackets (F) on Left Side Panel (A) and Right Side Panel (B) and secure each Bracket with one screw (I).
- Page 8 ASSEMBLY AND INSTALLATION INSTRUCTIONS DOUBLE HANGING UNIT NOTE: Use care when installing Hanging Rods (E) to avoid scratching finish inside unit. 9.1 Lower each Hanging Rod (E) into Rod Brackets (F) on Left Side Panel (A) and Right Side Panel (B).