Operation; Starting - Hamron 220-131 User Instructions

SE
Note!
• The appliance is equipped with an overpressure valve� The spray gun has a trigger lock�
• The motor is equipped with overheating protection� The appliance starts again after a few
minutes, when it has cooled�
• Operating temperature: 0 to 40°C�

STARTING

Note! The motor only works when the trigger is pressed�
1� Plug in the power cord�
2� Fully open the water tap�
3� Always keep the trigger pressed in when the motor is started�
4� Release the trigger lock and press the trigger for a few seconds to remove any air and relieve
the pressure in the hose�
5� Keep the trigger pressed and press the power switch to start the motor�
6� Apply chemicals on a dry surface with a wide spray pattern� Work from below and up on
vertical surfaces� Allow to act for a few minutes, but do not let it dry� Make sure that water is
not sprayed on surfaces that should not be wet�
4
Trigger
40

opERATIoN

5
Safety lock