Operation; High Pressure Mode - Hamron 220-137 User Instructions

WARNING! Do not adjust the nozzle when the trigger is pressed�
NB
• The motor only works when the trigger is pressed�
• Under no circumstances use the high-pressure washer in potentially explosive environments!
• The usage temperature must be between 0 and +40°C�
• The high-pressure washer consists of a unit with a pump which is enclosed in an impact-resistant
casing� For optimum working position, the high-pressure washer is supplied with a water-jet pipe
with a non-slip handle, the form and use of which complies with applicable rules�
• Do not cover over or modify the water-jet pipe or spray nozzle in any way�
• The high-pressure washer is designed for use with cold or warm water (max� 60°C); higher
temperatures can damage the pump�
• Do not use water that is dirty or that contains sand or chemicals, as this can have a negative
effect on usage and shorten the high-pressure washer's service life�
• The adjustable spray nozzle has two modes, high pressure and low pressure, which are adjusted
on the nozzle�
• Low pressure should be used in conjunction with cleaning agent�

HIGH PRESSURE mODE

The nozzle must be set at IN-position for high-pressure jets�
1� Turn the nozzle clockwise as far as it will go until there is no distance between the nozzle
and the base for high pressure mode/IN-position�
2� Turn the top of the nozzle clockwise or anticlockwise to obtain the required spray pattern�
Wide spray pattern
Narrow spray pattern

OPERATION

IN-position
EN
47