Table of Contents
Advertisement
On-Board FastRegen Control Module Programming and Operation Instructions
P/N 8040406
The REGEN program incorporates a number of parameters that are preset
at the factory, such as RATE-OF- RISE (10u/min.) and default base
pressure (50 microns). The On-Board FastRegen Control Module allows
you to reprogram the settings, within limits. This is normally done prior to
the start of a regeneration cycle. The On-Board FastRegen Control Module
also allows you to delay that start and completion of regeneration cycle.
This feature is desirable, for example, when you want to regenerate and
start up your cryopump system during a week-end shutdown. You can
reset the REGEN parameters by pressing the REGEN key and stepping
through the REGEN menu as shown in Table 3-1.
-
C
TI
CRYOGENICS
HELIX TECHNOLOGY CORPORATION
3-9
Hide quick links:
Advertisement
Table of Contents
