Maintenance Quick Reference Table - Daikin MCK55WVM Operation Manual

Maintenance
Maintenance

Maintenance Quick Reference Table

Check the reference pages for details on removing and attaching parts during cleaning/maintenance.
Outflow Grille
When dirt becomes an issue
• Wipe up dirt with a soft damp
cloth and rinse with water.
• Do not use a hard brush etc.
(Damage may result)
• When dirt buildup is severe,
leave the part soaking in
lukewarm or room temperature
water mixed with kitchen-use
neutral detergent, thoroughly
rinse off the detergent, and leave
the part in shade to dry off.
Unit
When dirt becomes an issue
• Wipe up dirt with a soft damp cloth.
• When dirt buildup is severe, wipe up the dirt with a cloth which has
been moistened with kitchen-use neutral detergent.
• Do not use a hard brush etc. (Damage may result)
Pre-filter
(Front/Left-side/Right-side)
About every 2 weeks
Vacuum clean
Wash/Rinse
• After removing any dust using a
vacuum cleaner, remove and
wash the filter with water and
then leave it in shade to dry off.
• Use a soft brush when cleaning
the spaces in the grid.
Attention
• Do not use a cotton bud or hard
brush etc.
(Partial breakage of the filter may
result)
• Do not apply heavy force.(Partial
breakage/damage of the filter may
result)
• When dirt buildup is severe,
leave the part soaking in
lukewarm or room temperature
water mixed with kitchen-use
neutral detergent, thoroughly
rinse off the detergent and leave
the part in shade to dry off.
23
Wipe Wash/Rinse
Removing
Place fingers
into the notches
in the top of the
unit and lift.
Attaching
Pay attention
to orientation
and attach
securely.
Wipe
Removing
Grip the notch in the
pre-filter and pull.
1 Grip either end of
the pre-filter resting
2 Pull toward
your thumb against
you.
the unit.
Attaching
Insert the hooks
(2 places) into
the unit and
press until you
hear a catching
sound.
Hooks
(2 places)
Reverse side
Insert the hook
Hook (1 place)
(1 place) into the
unit.
Push both ends
until securely
Viewed from above
attached.
WARNING
Before cleaning and maintenance work, be sure to unplug
the unit. (An electric shock or injury may result)
(Left-side)
(Front)
Dust/PM2.5 Sensor
When dust has built up
Vacuum clean
1 Remove the pre-filter (left-side).
2 Vacuum off any dust that has adhered to
the air intake for dust/PM2.5 sensor using
the vacuum cleaner crevice tool or similar.
Move the
catch and pull
Air intake for dust/PM2.5 sensor
About every 3 months
1 Remove the pre-filter (left-side) and the
cover for the air intake for dust/PM2.5
sensor.
Wipe the lens with a dry cotton bud.
2
Use the vacuum cleaner crevice tool or similar to
remove any dust that has built up around the lens.
3 Place the cover on securely.
(Malfunction may result if the cover is off)
(Right-
side)
Lens
(internal
part)
Wipe
Lens
Use a light if hard
to see