Daikin MCK55WVM Operation Manual page 19

MODE
Automatic airflow rate adjustment
FAN setting (Quiet, Low, Standard, High) is automatically adjusted according to the degree of air
impurity and humidity (when the Humidifying operation is active).
AUTO FAN
Purifying capacity increases as airflow rate rises.
• Press
• Degree of air impurity corresponds to the volume of dust and the intensity of odours in the ambient air.
Saving energy
In Power saving mode within ECONO MODE, the FAN setting automatically switches between Quiet
and Low only. Power consumption (*1) and operating sounds are reduced.
If the air is clean and the set humidity level has been achieved (when the Humidifying operation is
active), after a short while, Monitoring mode automatically activates.
Recommended for use during sleep hours.
*1 By comparison to AUTO FAN MODE (approx. 10.6Wh), power consumption in ECONO MODE (approx.
6.9Wh) is approx. 3.7Wh lower.
Test conditions: operation in 10m
after the unit was turned on.
Power saving mode
ECONO
FAN setting switches
automatically between
Quiet and Low.
• As the FAN setting is limited to Quiet and Low, air purifying and humidifying capacity is reduced.
• As air is not drawn in when the fan has stopped, the dust/PM2.5 sensor, odour sensor, and humidity sensor
reduce in sensitivity. To prevent this reduction in sensitivity, turn Monitoring mode OFF.
• FAN setting is adjusted automatically. Airflow cannot be adjusted manually.
• Press
Reducing pollen levels
ANTI- A gentle air current is created by switching every 5 minutes between the FAN setting Standard and
Low so that pollen can be drawn in and caught before it reaches the floor.
POLLEN
• FAN setting is adjusted automatically. Airflow cannot be adjusted manually.
• Press
Combating dry throat and skin
Humidity is automatically adjusted to be gentle on the throat and skin.
• As humidity is kept relatively high, if the temperature
difference between outdoors and indoors is large,
condensation may result.
• FAN setting is adjusted automatically. Airflow cannot be
MOIST
adjusted manually.
• Humidity level is set automatically. Humidity level cannot
be selected.
• If
MODE stops and AUTO FAN MODE is activated.
Humidity level will be the level selected previously.
Usage and Function
to select the humidity level.
2
If the air is clean and the set
humidity level has been
achieved, after a short while...
If the humidity level falls, or
dust or odours are
detected...
to select the humidity level.
to select the humidity level.
is pressed when MOIST MODE is active, MOIST
area over 1 hour. Assuming 1 cigarette was smoked immediately
• The fan starts and stops periodically. Dust,
odours, and the humidity level are
monitored.
• The following functions are turned off, further
reducing power consumption.
Streamer
Active plasma ion
*2 The humidifier ON/OFF lamp remains lit up.
„ Room conditions and target humidity
100
90
80
70
60
50
40
30
0
Useful Functions
Monitoring mode
OFF Humidifying OFF
OFF
►Page 22
70%
60 %
50 %
40%
10 15 20 25
Room temperature (°C)
(*2)
30
18