Changing The Airflow Rate; Using Humidifying And Air Purifying Operation; Adjusting The Humidity - Daikin MCK55WVM Operation Manual

Changing the Airflow Rate

Select the desired FAN setting.
*
*
: Quiet : Low
Remote controller
Press
.
• Each press cycles between the FAN
lamps [green].
(Quiet) (Low)
(Turbo) (Standard)
About FAN settings
A gentle breeze is emitted. Recommended for use during sleep hours.
Quiet
As the deodorising capacity is reduced, it is recommended that the FAN setting be set to Standard or above if
odour needs to be quickly eliminated from a room.
The ambient air is quickly purified using a large airflow. Recommended for use while you are cleaning up a room.
Turbo

Using Humidifying and Air Purifying Operation

Humidifies and cleans the air in the room.
Fill the water tank with water.
Remote controller
Press
.
• Press the button again to cancel the operation.
• The humidifier ON/OFF lamp [orange] lights up.
Attention
Make sure that the humidifying filter unit is attached when using
this operation.
Be sure to use tap water for the water in the water tank.
Change the water in the humidifying tray and water tank everyday.
As leaving any residual water in the humidifying tray will lead to
bad odours and dirt build-up, be sure to discard any residual
water in the humidifying tray each time the water tank is refilled.
• Air purification is always performed with
humidification.
(It is not possible to run the Humidifying operation
exclusively.)
• When the target humidity level is reached or the water
supply lamp lights up, the Humidifying operation stops.
However, the Air purifying operation continues.
Note
• Indoor temperature may fall when the Humidifying
operation is running.
• Burbling or splashing sounds may be generated when
the Humidifying operation is running, however, this is
normal (not a malfunction).
• If or is pressed when MOIST MODE is active, the
Humidifying operation stops and AUTO FAN MODE is activated.
*
: Standard : Turbo
Unit
Press
• Each press cycles between the FAN lamps [green] and MODE lamps [green].
(Quiet)
(MOIST)
►Page 13
Unit
Press
.
►Page 32
* The size of the symbols varies in accordance
with the FAN setting.
.
FAN
(Low)
(ANTI-POLLEN)
MODE

Adjusting the Humidity

Select the desired humidity level.
Remote controller
Press
.
• Each press cycles between the humidity lamps [green].
(Low)
About humidity settings
Targets a humidity level of around 40%*.
Low
Targets a humidity level of around 50%*.
Standard
Targets a humidity level of around 60%*.
High
* Depending on room conditions such as indoor and outdoor
temperatures and humidity levels, the target humidity level
may be exceeded (or not reached).
Note
• If is pressed when the Humidifying operation is
OFF, the Humidifying operation turns ON.
• Humidity level cannot be selected when MOIST MODE
is active.
If is pressed when MOIST MODE is active, MOIST
MODE stops and AUTO FAN MODE is activated.
Humidity level will be the level selected previously.
(Standard) (Turbo)
(ECONO) (AUTO FAN)
Unit
Cannot be set from unit.
(Standard) (High)
►Page 36
Operation
16