Page 2
The HDBaseT Extender 4K@60HZ 4:2:0 Control Path has been tested for conformity to safety regulations and requirements, and has been certified for international use. However, like all electronic equipment, the JTECH-HDBT73 should be used with care. Please read and follow the safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit.
INTRODUCTION The JTECH-HDBT73 is an HDBaseT Extender set consist of transmitter (TX) and receiver (RX). It distributes HDMI signal via CAT5e/CAT6a cable at 70m/PoC, and enables IR and RS232 pass-through to control local source device from remote or far-end display.
PANEL DESCRIPTION Front Rear HDCP LINK Name Description ① Power LED Illuminates red when power is applied. Euroblock/Phoenix connector for connecting an ② RS232 RS232 data device. HDMI port for connecting the video source device HDMI IN (TX) (e.g. Blu-ray DVD) ③...
SYSTEM CONNECTION Usage Precautions Make sure all components and accessories included before installation. System should be installed in a clean environment with proper temperature and humidity. All of the power switches, plugs, sockets, and power cords should be insulated ...
SPECIFICATION Model Transmitter (TX) Receiver (RX) Spec Input HDMI IN HDBT IN Output HDBT OUT HDMI OUT Control IR IN, IR OUT, RS232 IR IN, IR OUT, RS232 General Maximum Video 4K×2K@60Hz 4:2:0, including 1080p@60Hz Resolution Transmission Mode HDBaseT Transmission Distance 1080p signal to 70m, 4K signal to 40m Bandwidth 10.2Gbps...
TROUBLESHOOTING & MAINTENANCE No image on display: Ensure that the display device has been set to the correct input. Ensure that the HDMI cables used for both the source/transmitter and the receiver/display are properly connected and are working. Test the HDMI cables directly from a source to display and ensure their operation.
Page 12
Specifications, pictures & software described herein are subject to change without prior notification. Only use the provided power supply when operating this unit. J-Tech Digital® is not responsible for any damage due to customer neglect. All trademarks are the sole property of their respective companies.