Call Setup Status - Tait TM8000 Series Applications Manual

3.2.10

Call Setup Status

Configuration
Timing
Description
Related Actions
TM8000 3DK Hardware Developer's Kit Application Manual
September 2003 © Tait Electronics Ltd
This output signal is activated when the radio is busy in a voice call.
It remains active as long as the call is in progress, and may be used to trigger
an application such as a voice recorder, or to quieten external audio
equipment during the call.
1. Configure an output line and associate it with this action. Set the
active state to be high or low (as required).
2. Configure the Monitor function to activate on both call reception
and call initiation. Set the Monitor Auto-Quiet timer to minimise the
chance of turning the Monitor off in the middle of a call.
The call setup status signal will respond within 2ms of monitor activation
during call setup or reception.
This output signal is activated when the monitor function is activated by
either a call setup or call reception.
The signal will be deactivated when the call is finished i.e. when the monitor
is deactivated again due to auto-quiet timeout or reset signalling.
Note
The monitor function does not get activated if the call is deter-
mined to be non-voice e.g. contains a control status.
None.
Programmable I/O Lines 75