Home Channel - Tait TM8000 Series Applications Manual

3.1.11

Home Channel

Application
Configuration
Timing
Description
Related Actions
TM8000 3DK Hardware Developer's Kit Application Manual
September 2003 © Tait Electronics Ltd
This input signal is used to change to a specified reference channel, which
can then be used to increment or decrement from.
1. Configure a list of channels.
2. Configure an input line and associate it with this action. Set the active
state (high or low) and the debounce time (0 to 100ms).
3. On the same form, select the home channel.
Allow 10ms before applying another channel change action.
When this input line is activated, the radio changes to the home channel.
This input line is of a momentary type and therefore no action is performed
on its deactivation.
If the input line is active while the radio is powered up, it must be re-applied
for the action to be carried out.
The 'Preset Channel' input signal is used to temporarily select a pre-
programmed channel
The 'BCD Pin 0 to 4' input signal is used to change to a specified channel
number.
The 'Increment Channel' and
to increment or decrement the current channel by one.
'Decrement Channel' input signals are used
Programmable I/O Lines 53