Tait TM8000 Series Applications Manual page 84

Tap In and Tap Out
Unmute
Applications
84 Programmable I/O Lines
Table 3.8 Tap out points and tap out types
Tap out
Rx/PTT type
points
Rx R1
R2
R4
R5
R7
R10
PTT, EPTT1, EPTT2 T3
T4
R10
Note
If a tap type is set to 'Splice', then the corresponding tap in or tap
out type must also be set to 'Splice'. Both tap points and both
unmute conditions must also be identical.
For the Rx path, the settings for unmuting the tap in and the tap out points
are:
Busy Detect
I
Busy Detect and Subaudible
I
Rx Mute Open
I
Except on PTT (not available for tap type E - Splice)
I
For all PTT types, the only setting for unmuting the tap in and the tap out
points is On PTT
For application examples refer to:
"External Modem" on page 98
I
"Encryption Module (Scrambler)" on page 107
I
"ANI Module" on page 113
I
Tap out Tap in
types points
C - Bypass Out R7
D - Split
C - Bypass Out R10
D - Split
C - Bypass Out
D - Split
C - Bypass Out
D - Split
C - Bypass Out
D - Split
E - Splice
C - Bypass Out
D - Split
C - Bypass Out T3
D - Split
E - Splice T4
C - Bypass Out T5
D - Split
T8
T12
T13
TM8000 3DK Hardware Developer's Kit Application Manual
September 2003 © Tait Electronics Ltd
Tap in
types
E - Splice
A - Bypass In
B - Combine
A - Bypass In
E - Splice
A - Bypass In
A - Bypass In
A - Bypass In
A - Bypass In