Provision For External Options Connector; Provision For Additional Connector - Tait TM8000 Series Applications Manual

2.5

Provision for External Options Connector

2.6

Provision for Additional Connector

TM8000 3DK Hardware Developer's Kit Application Manual
September 2003 © Tait Electronics Ltd
The radio has a mechanical interface for the external connector of an
internal options board. This external options connector can be a 9-way
standard-density or 15-way high-density D-range connector. If no internal
options board is installed (standard configuration), the hole for the external
options connector is sealed by a bung.
Examples of internal options boards:
TMAA30-02 3DK Application Board.
I
Refer to the TM8000 3DK Application Board Service Manual.
TMAA01-01 Line-Interface Board.
I
Refer to the TM8100 Mobile Radio Accessories Manual.
TMAA01-05 Options Extender Board.
I
Refer to the TM8100 Mobile Radio Accessories Manual.
For information on how to create your own internal options board, refer to
"Internal Options Board" on page
The radio has a provision to fit an additional round connector or cable exit
next to the external options connector on the rear of the radio. The position
is indicated in Figure 2.2 on page
7.5 mm, suitable for an SMA connector or a cable grommet.
Important
When fitting an additional connector, it is the integrator's
sole responsibility to provide adequate sealing.
85.
16. The maximum hole diameter is
Description of the Radio Interfaces 31